Elesa+Ganter GN 875 swing clamp for use with lathes.
Swing clamps GN 875 are used when the clamping point for inserting and removing the workpiece must be freely accessible on top. During the clamping action, the arm is first swiveled by 90° and lowered, followed by the linear tensioning motion. The workpiece clamping must take place within the clamping stroke. The angle orientation of the tensioning arm can be set arbitrarily during mounting on the swing clamp. When tightening the screw, the piston rod must not experience any torque. The clamping arm must therefore be held to prevent twisting. The swing clamps are equipped with a magnet ring piston and are therefore pre-fitted for end stop detection via sensor.
Coding:
– Type L: swiveling left
– Type R: swiveling right
Types:
– Type A: Clamping arm with slotted hole and 2 flanged washers
– Type AC: Clamping arm with slotted hole, 2 flanged washers and GN 708.1 spindle assembly
– Type B: Clamping arm with threaded hole
– Type F: Adapter flange
– Type N: without clamping arm
Material:
– Body in aluminum, hard anodized with wear-resistant surface
– Double-action air cylinder, max. pressure 6 bar
– Socket cap screw DIN 912, Steel, zinc plated, blue passivated
– Washer ISO 7092, Steel, zinc plated, blue passivated
– Spindle assembly GN 708.1 type A, Steel, zinc plated, Rubber tip 85 Shore A
Accessory:
– GN 875.2 Clamping arms
– GN 875.3 Clamping arms
– GN 875.4 Adapter flanges
– GN 3380 Sensor
